top of page

CELLINK NEO Series

​Enjoy Vueroid's parking mode with a peace of mind using the latest Cellink batteries.
The Cellink is built with the safest battery technology using LiFePO4 (lLithium Iron Phosphate) which will keep your dashcam running for long hours in parking mode with just 50 minutes of charging.  Continuing on the success of the best selling Cellink NEO 8+, the NEO 8+ S is the latest dashcam battery pack built to deliver the ultimate combination of power, durability and reliability. Now, with new circuitry design for better performance and faster Bluetooth connectivity.

ADVANCED TECHNOLOGY

Rapid Charging Technology, charges fully within 40 minutes of driving.
Advanced Microcontroller (MCU) for efficient charging control.

LONG LASTING

​High capacity battery.
Supplies up to 48 hours of power in parking mode.
Using the safest cell material, LiFePO4.

RELIABLE

Long cycle life up to 2,000 cycle.
Stable performance.
​Manufactured in Republic of Korea since 2013

PROTECT

Protect new car warranty.
Support simple installation to cigar jack socket.
Prevent electrical errors especially on continental cars.
Covered with product liability insurance.

SAFE

Protect car battery performance and life.
High temperature Cuts-Off and Protection Circuit Module (PCM). 
​Short Circuit Protection Control

PROVEN

Approved and used by most car agents in Singapore.
Certified with CE standard; meeting high safety, health and environmental protection requirements. 

Cellink NEO 8+S dashcam battery

NEO 8+S

WORLDWIDE

  • 12.8V | 7,500mAh | 96.0Wh

  • Built-in Bluetooth  (smartphone app support)

  • Expandable with NEO Extended

  • 5V USB 3.0 port to charge acc. 

Cellink NEO 5 dashcam battery

NEO 5

WORLDWIDE

  •  12.8V | 4,500mAH | 57.6Wh

Cellink NEO Extended dashcam battery

NEO EXTENDED

WORLDWIDE

  • 12.8V | 6,600mAH | 84.5Wh

  • To extend the capacity and Parking ​Mode time

  • Need main Neo battery to work​

Cellink batteries basic features
Cellink battery installation illustration

​Cellink Battery supports two charging modes:
• Simple installation:
Just plug the battery into the cigarette lighter socket of your vehicle.

• Hardwired installation: 
For rapid charging speed, connect the battery to the fuse panel.

When vehicle's ignition is switched ON, Cellink Battery charges and supplies power to the dashcam. 

When vehicle's ignition is switched OFF, Cellink Battery supplies power to the dashcam independently until power depletes. 
Above setup will not interfere with car battery's performance and life. 

HOW DOES IT WORKS?

the-risk-of-using-car-battery-for-dashcam-parking-mode-use-cellink-battery_2_orig.jpg

Car start

failure

To power dashcams for parking mode is a challenging problem where mobile power is needed. Even though car battery has much higher capacity than Cellink battery, it is not designed for routine deep discharge cycles while car is parked hence its performance may deteriorate and life is shortened prematurely over time.

Automotive batteries perform differently from regular lithium ion batteries. Batteries for vehicles last much longer when stored in a charged state. The instability caused by leaving it discharge most of the time (during parking mode), will increase the sulfation process, resulting in the built up of lead sulphate crystals.

A sulfated battery can lead to loss of cranking power (risk of unable to start), longer charging time, shorter running times between charges and shorter battery life. Prolong discharge of car battery may cause electrical error on dashboard! Learn more >.

WHY NOT USING CAR BATTERY?

Cellink battery manager app

​Cellink battery is normally installed in the location out of your sight.
Cellink NEO 8+ S supports Bluetooth for compatibility with free Cellink NEO Battery Manager app (iOS/ Android) hence you can easily connect with your smartphone.

Cellink NEO Plus app

When charging, the app displays charge percentage, charging voltage and expected remaining time until full charge.
When ignition is off, the app informs you of the expected Parking Mode remaining time until depletion, based on the dashcam’s power consumption.

BATTERY MANAGER

APP

Cellink NEO with extended battery

EXTENDED BATTERY FOR DOUBLE CAPACITY

NEO and NEO 8+ S comes with Extended Battery port which you can connect to the NEO Extended Battery to expand the capacity and Parking Mode time. Please refer to the specifications here.
​The NEO Extended Battery can store up to 6600mAh of power, it's 10% more power than the main NEO battery. Multiple Extended Battery units can be connected in sequence to provide even larger capacity. 

EXPANDABLE

Cellink NEO rapid charging switch

To enjoy the rapid charging time of 50 minutes for NEO 8+ S, it needs to be hardwired to fuse panel. 
Alternatively, it also supports simple installation to cigar jack (optional power cable) with charging time of 100 minutes.

While NEO 8+ S comes with selectable charging mode switch:
1) ADJ (4.0 to 9. Ampere) - HIGH / Rapid Charging (hardwired) -adjustable with Cellink NEO Plus App

2) FIX (4.5 Ampere) - LOW / Fix Charging (cigar jack)

RAPID CHARGING

Cellink battery car cigar charger cable

Cigar Jack cable for Cellink NEO (3 metres length)

Cellink NEO battery AC charger

Home charger  (2.5 metres cable length)

OPTIONAL 
ACCESSORIES

Note: Cellink batteries are manufactured by Egen Inc, Korea

POWER DURATION

& SPECS

NEO spec
bottom of page